>>Application
This method is applicable to wastewater with total lead concentrations within the range of 0-20 mg/L.
>>Technical parameters
1. Measurement Method: Tetrasulfonated Porphyrin Spectrophotometric Method
2. Measurement Range: 0-5 mg/L, OEM 0-20mg/L
3. Accuracy: ≤±10%
4. Repeatability: ≤±5%
5. Measurement Cycle: Minimum cycle is 30 minutes; color development time can be adjusted flexibly between 5-30 min based on environmental conditions.
6. Sampling Cycle: Adjustable time interval (10-9999 min) or on-the-hour measurement mode.
7. Calibration Cycle: Adjustable at any interval from 1-99 days.
8. Maintenance Cycle: ≥168 hours, with each maintenance lasting ~1 hour.
9. Reagent Consumption: <0.50 CNY per sample.
10. Outputs: RS-232, 4mA-20mA, RS-485.
11. Environmental Requirements: Temperature-controlled indoor environment (recommended: 5-40°C); humidity 45%-85%.
12. Power Supply: AC 220±10% V, 50±1% Hz, 5A.
13. Dimensions: Height 1500 × Width 500 × Depth 450 mm.
14. Additional Features:
- Data retention during abnormal alarms or power outages.
- Touchscreen display and command input.
- Automatic discharge of residual reactants and resumption of operation after power restoration or system reset.
>>Feature
Unique Design: This product features a distinctive design that ensures lower failure rates, reduced maintenance requirements, minimal reagent consumption, and higher cost-effectiveness compared to similar products.
-
Selector Valve Assembly:
- Enables flexible reagent sampling timing and diverse channel configurations.
- Minimizes dead volume for easy maintenance and extended service life.
-
Micro-Dosing Unit:
- Utilizes a visual photoelectric system for precise reagent measurement, eliminating quantitative errors caused by peristaltic pump tube wear.
- Achieves accurate micro-dosing with 0.7 mL per dose, significantly reducing reagent usage.
-
Sample Introduction Unit:
- Employs a peristaltic pump with negative pressure suction, creating an air buffer zone between reagents and the pump tube to prevent corrosion.
- Simplifies and enhances flexibility in reagent mixing.
-
Sealed Digestion Unit:
- Operates under high-temperature and high-pressure conditions to accelerate reactions.
- Eliminates corrosion risks from volatile gases in open systems.
-
Reagent Tubing:
- Uses imported modified PTFE (polytetrafluoroethylene) transparent tubing with an inner diameter >1.5 mm to minimize clogging by particulate matter in water samples.
>>Analytical Principle
Following acid digestion, the water sample is combined with a pH-adjusting reagent and subsequently oxidized with potassium persulfate. Under alkaline conditions (pH 10.5 ± 0.2) in the presence of dithizone as the chromogenic agent, lead(II) ions form a cherry-red dithizonate chelate complex (λ<sub>max</sub> = 520 nm). A microprocessor-controlled spectrophotometer quantifies lead concentration through differential absorbance measurement calibrated against NIST-traceable standards, with chelate complex concentration demonstrating linear correlation (R<sup>2</sup> ≥ 0.995) to total lead content.
